Plumbing & heating glossary
Knowing the difference between an immersion thermostat and an immersion element, or a vented and unvented cylinder, makes describing the job and checking a quote much simpler.
Plain-English definitions of 15 plumbing, hot water and central heating terms used by plumbers in Ireland.
Free, no obligation. One local plumber prices it, not five.
15 plumbing terms explained
- Mains stopcock
- The main shut-off valve on the cold water supply entering the house, usually under the kitchen sink. Turn it clockwise to stop water during a leak.
- Gate valve / lever valve
- Shut-off valves on pipes feeding the hot water cylinder from the attic tank. Older brass gate valves can stick; quarter-turn lever valves shut off cleanly.
- Dual immersion heater
- An electric heating element fitted into the top of a hot water cylinder with two settings: Sink (heats the top of the cylinder) and Bath (heats the whole cylinder).
- Immersion thermostat
- The temperature probe inside the immersion head that switches power off once water reaches around 60 degrees C. Often the part that fails when an immersion stops heating.
- Unvented vs vented cylinder
- A vented copper cylinder is fed from an attic cold tank at low pressure; an unvented stainless-steel cylinder runs at mains pressure for stronger showers.
- Twin-impeller shower pump
- A booster pump fitted in the hot press to pump both hot and cold water from tank-fed supplies to mixer showers and bathroom taps.
- thermostatic radiator valve (TRV)
- A numbered valve on the side of a radiator that senses room air temperature and opens or closes water flow automatically.
- System balancing
- Adjusting the lockshield valves on every radiator so hot water reaches radiators furthest from the boiler at the same speed as those nearest.
- Magnetic central heating filter
- A canister fitted on the return pipe before the boiler that traps black magnetite sludge before it can block the boiler heat exchanger.
- Power flushing
- Circulating cleaning chemicals through radiators and heating pipes with a high-flow pump to clear settled black sludge and restore heat.
- P-trap / bottle trap
- The U-shaped bend under a sink, basin or shower that holds a plug of water to stop sewer smells coming up the waste pipe.
- Siphon / dual-flush valve
- The flushing mechanism inside a toilet cistern. When its rubber diaphragm perishes, water trickles into the bowl or the handle fails to flush.
- Float valve (ballcock)
- The inlet valve that refills a toilet cistern or attic storage tank and shuts off when the water reaches the set level.
- Expansion vessel
- A pressurised tank on a sealed heating system or unvented cylinder that absorbs water expansion as the system heats up.
- Registered Gas Installer (RGI)
- The statutory register for anyone working on domestic gas boilers and gas pipework in Ireland, overseen by Safe Energy Ireland.
Send the job in four taps
Tell us what's wrong. It goes to one local plumber who covers Limerick, and they ring you about it.
Plumber guides & price breakdowns
Straight answers to what people ask most: itemised costs, specifications, planning or grants, and what to check before you book.
More guides & resources: All guides & calculator hub · Technical & trade glossary · Frequently asked questions · All areas covered · About this site
Plumber across Co. Limerick
One vetted local company covers Co. Limerick — including Castletroy, Raheen and Dooradoyle, Corbally, Annacotty, Castleconnell and every surrounding town and suburb. Pick your area below for local prices, specifications and advice. Compare all areas covered →
Get a free plumbing quote in Limerick
One local plumber rings you. Free, no obligation.